Lateral Accelerometer: Service and Repair

SENSOR-DYNAMICS

REMOVAL





1. Remove the center console.
2. Disconnect electrical connector (3) from the dynamics sensor (2).
3. Remove the two nuts (1) securing the sensor to the floor.
4. Remove the sensor (2).

INSTALLATION





1. Install the dynamics sensor (2) on the studs (4) to the vehicle.

NOTE: Make sure the electrical connector is facing toward the rear of the vehicle.

2. Connect the electrical connector (3) to the sensor (2).
3. Install the two retaining nuts (1) and tighten to 6 Nm (53 inch lbs.).
4. Install the floor console.
5. Perform the ABS verification test with the scan tool.