Heated Glass Element Relay: Service and Repair

RELAY-REAR WINDOW DEFOGGER

REMOVAL





1. Disconnect and isolate the negative battery cable.
2. Remove the trim cover from the cowl (2) on the driver side of the vehicle.
3. Locate the junction block (JB) (1).

NOTE: Refer to the fuse and relay map on the inside of the JB cover for EBL relay location.

4. Remove the EBL relay from the JB.

INSTALLATION






NOTE: Refer to the fuse and relay map on the inside of the junction block (JB) cover for EBL relay location.

1. Position the EBL relay into the proper receptacle of the JB (1).
2. Align the EBL relay terminals with the terminal cavities in the JB receptacle and push down firmly on the relay until the terminals are fully seated.
3. Install the trim cover onto the driver side cowl (2).
4. Reconnect the negative battery cable.