Key/Lock Cylinder

KEY/LOCK CYLINDER

REMOVAL
1. Disconnect negative cable from battery.





2. Remove the lower shroud (2) from steering column.
3. Place shifter in PARK position.
The ignition key (2) must be in the key cylinder (1) for cylinder removal.





4. A retaining pin is located at side of key cylinder assembly.
a. Rotate key (2) to RUN position.
b. Press in on retaining pin with a small punch (3), while pulling key cylinder (1) from ignition switch.





5. Remove the key (2) and key cylinder (1) from the column (3).

INSTALLATION





The ignition key (2) must be in the key cylinder (1) for cylinder installation.
1. Install the key cylinder (1) into the housing (3) using care to align the end of the key cylinder with the ignition switch.
2. Push the key cylinder (1) in until it clicks.
3. Replace the lower shroud.
4. Reconnect the battery