Lamp - Cab and Chassis

REMOVAL




1. Disconnect and isolate the negative battery cable.
2. Disconnect the rear lamp unit pigtail wire connector (2) from the chassis wire harness connector for the rear lamp.
3. Disengage the rear lamp unit pigtail wire and connector from the rear frame rail.
4. Remove the two nuts (1) that secure the studs (3) on the rear lamp unit housing (4) to the lamp mounting bracket (5) on the rear frame rail.
5. For the left side lamp only, remove the license plate mounting bracket (6) from the rear lamp unit studs.
6. Remove the rear lamp unit from the mounting bracket while feeding the pigtail wire and connector through the bracket.

INSTALLATION




1. Feed the pigtail wire and connector (2) of the rear lamp unit (4) through the lamp mounting bracket and position the lamp studs (3) through the mounting holes in the bracket.
2. For the left side lamp only, position the license plate mounting bracket (6) onto the rear lamp unit studs.
3. Install and tighten the two nuts (1) that secure the rear lamp unit housing to the mounting bracket. Tighten the nuts to 5 N.m (47 in. lbs.).
4. Reconnect the rear lamp unit pigtail wire connector to the chassis wire harness connector for the rear lamp.
5. Engage the rear lamp connector retainer into the rear frame rail.
6. Reconnect the negative battery cable.