Lamp - Rear Fender

NOTE: These lamps are used on pick-up models with dual rear wheels. A lamp with an amber lens is located on the rear fender ahead of each rear wheel opening, and a lamp with a red lens is located on the rear fender behind each rear wheel opening. The service procedures are identical for all four of these lamps.

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Using hand pressure, press the rear edge of the rear fender marker lamp lens/housing (3) toward the front of the vehicle against the spring pressure of the retaining clip (4), then pull the rear edge of the lamp outward to disengage it from the mounting hole (1) in the rear fender.
3. Pull the marker lamp out from the rear fender far enough to access and disconnect the wire harness connector (2) from the bulb socket (5) on the back of the lamp lens/housing.
4. Remove the marker lamp from the rear fender.

INSTALLATION




1. Position the marker lamp (3) close enough to the mounting hole (1) to access and reconnect the wire harness connector (2) to the bulb socket (5) on the back of the lamp lens/housing.
2. Engage the retaining clip (4) on the front edge of the marker lamp into the front edge of the mounting hole in the rear fender.
3. Using hand pressure, press the rear edge of the marker lamp lens/housing toward the front of the vehicle against the spring pressure of the retaining clip, then push the rear edge of the lamp into the rear of the mounting hole in the rear fender.
4. Reconnect the battery negative cable.