Bearing Output Shaft Front

BEARING OUTPUT SHAFT FRONT

REMOVAL
1. Remove overdrive unit from the vehicle.





2. Remove overdrive geartrain (5) from housing.
3. Remove snap-ring (2) holding output shaft front bearing (1) to overdrive geartrain (5).
4. Pull bearing (1) from output shaft (3).

INSTALLATION





1. Place replacement bearing (1) in position on geartrain (5) with locating retainer groove toward the rear.
2. Push bearing (1) onto output shaft (3) until the snap-ring groove is visible.
3. Install snap-ring (2) to hold bearing onto output shaft (3).
4. Install overdrive geartrain (5) into housing.
5. Install overdrive unit in vehicle.