Tie Rod: Service and Repair

TIE ROD END

REMOVAL





1. Remove tie rod nuts (1).
2. Remove tie rod from drag link and left knuckle with remover C4150A.

INSTALLATION





1. Install tie rod (2) to the left steering knuckle and drag link. Install the nuts (1) and tighten to 54 Nm (40 ft. lbs.) Then an additional 90°.
2. Remove the supports and lower the vehicle to the surface. Center steering wheel and adjust toe.
3. After adjustment tighten tie rod adjustment sleeve clamp bolts to 61 Nm (45 ft. lbs.).

NOTE: Position the clamp on the sleeve so retaining bolt is located on the bottom side of the sleeve.