Bearing Output Shaft Rear

BEARING OUTPUT SHAFT REAR

REMOVAL
1. Remove overdrive unit from the vehicle.
2. Remove overdrive geartrain from housing.





3. Remove snap-ring (3) holding output shaft rear bearing (1) into overdrive housing (2).
4. Using a suitable driver inserted through the rear end of housing, drive bearing from housing.

INSTALLATION





1. Place replacement bearing (1) in position in housing (2).
2. Using a suitable driver, drive bearing (1) into housing (2) until the snap-ring groove is visible.
3. Install snap-ring (3) to hold bearing into housing.
4. Install overdrive geartrain into housing.
5. Install overdrive unit in vehicle.