Fuel Level Sensor: Service and Repair

REMOVAL
The fuel level sending unit (fuel level sensor) and float assembly (7) is located on the side of the fuel pump module.




1. Remove fuel pump module from fuel tank.
2. Disconnect 4 wire electrical connector (3) from fuel pump module. Separate necessary sending unit wiring from connector using terminal pick/removal tool. Refer to Special Tools for tool part numbers.




3. To remove sending unit from pump module, lift on plastic locking tab while sliding sending unit tracks.

INSTALLATION
1. Connect necessary wiring into electrical connectors. Connect 4 wire electrical connector to pump module.
2. Position sending unit to pump module. Slide and snap into place.
3. Install fuel pump module.