Front Seat Back
SEAT BACK - FRONTREMOVAL
1. Disconnect and isolate battery negative cable.
2. Remove seat cushion.
3. Verify that seat back is in full upright position.
Fig. 3:
4. Disconnect lumbar support hose, if equipped.(Fig. 3)
5. Remove seat back bolts and remove seat back.
INSTALLATION
1. Remove stop screw.
2. Install seat back locking spline side first.
NOTE: For better centering of seat back in the mounting bore during installation, operate the seat back release lever once.
3. Install the spline side seat back bolt.
4. Install remaining seat back side.
NOTE: It may be necessary to press the guide tabs apart slightly.
5. Install the remaining seat back bolt.
6. Tighten the seat back bolts to 20 N.m (15 ft.lbs.).
7. Place seat back in the foremost position until the hold down spring latches audibly.
8. Install stop bolt and tighten to 20 N.m (15 ft.lbs.).
9. Connect the lumbar support hose, if equipped.
10. Check seat back operation.
11. Install the seat cushion.