Repeater Lamp Unit Replacement

SMALL

REMOVAL
1. Disconnect and isolate the battery negative cable.

Small Repeater Lamp Unit Remove/Install:

2. Using hand pressure, press the rear edge of the repeater lamp lens/housing toward the front of the vehicle against the spring pressure of the retaining clip, then pull the rear edge of the lamp outward to disengage it from the mounting hole.
3. Pull the repeater lamp housing slightly to the rear to disengage the front edge of the unit from the mounting hole.
4. Disconnect the vehicle wire harness connector from the connector receptacle of the bulb holder on the back of the repeater lamp unit.
5. Remove the repeater lamp unit from the vehicle.

INSTALLATION
1. Position the repeater lamp unit to the mounting hole on the fender panel.
2. Reconnect the vehicle wire harness connector to the connector receptacle of the bulb holder on the back of the repeater lamp unit.
3. Engage the front edge of the repeater lamp unit into the front edge of the mounting hole.
4. Using hand pressure, press the rear edge of the repeater lamp lens/housing toward the front of the vehicle against the spring pressure of the retaining clip, then push the rear edge of the lamp into the rear of the mounting hole.
5. Reconnect the battery negative cable.

LARGE

REMOVAL
1. Disconnect and isolate the battery negative cable.

Large Repeater Lamp Unit Remove/Install:

2. Remove the screw that secures the lens and the repeater lamp housing to the fender panel.
3. Pull the repeater lamp lens and housing outward to disengage the unit from the mounting hole.
4. Disconnect the vehicle wire harness connector from the connector receptacle on the back of the repeater lamp unit.
5. Remove the repeater lamp unit from the vehicle.

INSTALLATION
1. Position the repeater lamp unit near the mounting hole on the fender panel.
2. Reconnect the vehicle wire harness connector to the connector receptacle on the back of the repeater lamp unit.
3. Position the repeater lamp lens and housing to the mounting hole as a unit.
4. Install and tighten the screw that secures the lens and the repeater lamp housing to the fender panel.
5. Reconnect the battery negative cable.