Fog/Driving Lamp: Adjustments

VEHICLE PREPARATION FOR FRONT LAMP UNIT ALIGNMENT
1. Verify headlamp dimmer (multi-function) switch, fog lamp switch (if equipped), and high beam indicator operation.
2. Verify that the headlamp leveling switch is in the "0" position.
3. Repair or replace any faulty or damaged components that could interfere with proper lamp alignment.
4. Verify proper tire inflation.
5. Clean front lamp unit lenses.
6. Verify that the cargo compartment is not heavily loaded. Vehicle should be at or near curb weight.
7. The fuel tank should be "Full." Add 2.94 kilograms (6.5 pounds) of weight over the fuel tank for each estimated gallon of missing fuel.
8. Load the driver's seat with 75 kilograms (165 pounds) of weight.

FROST LAMP UNIT ALIGNMENT
1. Position the vehicle on a level surface.
2. Turn On the headlamp low beams or the fog lamps (if equipped).
3. Open the hood.
4. Set up the headlamp adjuster according to the instructions provided by the manufacturer of the unit.

Front Lamp Unit Adjusting Screws:

5. Adjust the front lamp unit reflector as required by turning the adjustment screws in or out.

Low Beam Headlamp Cut-Off Pattern:

Fog Lamp Cut-Off Pattern:

6. When properly aligned, the low beam headlamps and, if equipped, fog lamps should provide a cut-off pattern. Repeat the adjustment procedure as necessary to obtain the recommended cut-off patterns.