Installation

INSTALLATION
1. Position flipper shield position on seat.

2. Using needle nose pliers, hook spring leg over rear small rod on risers assembly.

3. Snap two plastic clips to the two small rods, one on cushion frame and one towards rear of riser assembly (same rod spring leg is on).

4. Repeat steps (1), (2), & (3) for opposite flipper shield on opposite side of seat.

5. Repeat steps (1), (2), (3), & (4) for other seat.

6. Install seat lower cushion side shields -O/B & I/B.

7. Install seat upper cushion side shields.