Fluid Drain And Fill

FLUID DRAIN AND FILL

The fluid required in this transaxle is Mopar(R) ATF+4. Use of substitute fluids may result in improper transaxle operation and/or failure.


FLUID DRAIN

1. Raise vehicle on hoist.
2. Remove transaxle drain plug (Figure 1) and drain fluid into suitable container.
3. Install drain plug and torque to 23 Nm (17 ft. lbs.).




Figure 1 Transaxle Drain Plug







FLUID FILL

1. Remove transaxle fill plug (Figure 2).
2. Add 2.4-2.7L (2.5-2.9 qts.) of Mopar(R) ATF+4 until fluid is within 3/16" below fill hole.
3. Install fill plug, ensuring it is properly seated.
4. Lower vehicle.




Figure 2 Transaxle Fill Plug