Installation

INSTALLATION




1. Carefully lower the door glass into the door (5) through the window opening.

2. Rotate the door glass into position and engage it to the window regulator.

3. Position the front glass run channel (1) into the door through the door panel opening (4).

4. Engage the two bolts (2 and 3) that secure the front glass run channel to the door. Tighten the bolts to 10 Nm (89 in. lbs.).





5. Install the two nuts (1) that secure the door glass to the window regulator (2) through the two sight windows (3 and 4). Tighten the nuts to 10 Nm (89 in. lbs.).

6. Lower the door glass into the door and remove the manual window crank or disconnect the electric window switch from the door wire harness (depending on application).

7. Install the waterdam.

8. Install the inner belt molding.