Service Procedure

1. Position the glass in the mirror as shown in Figure 1 to access the two outboard mirror housing cover retainer clips.





2. Using a plastic trim stick, disengage the three mirror housing retainer clips (start with the two outboard clips) and remove the housing cover (Figure 2).





3. Disengage the mirror glass retainer clips from the mirror motor and remove the glass from the motor (Figure 3).

4. Vehicles with heated mirrors, disconnect the wire harness connectors from the mirror glass.

NOTE:
When disconnecting the wire harness connectors from the heated mirror glass terminals, mark the location of each connector and its respective terminal for installation reference.





5. Position the mirror housing cover onto the mirror housing and engage the three retainer clips (Figure 4).

NOTE:
Be sure that all three retaining clips are fully engaged.

6. Vehicles with heated mirrors, connect the wire harness connectors to the heated glass mirror terminals.

NOTE:
Connect each heated mirror glass electrical connector to its respective mirror terminal as marked during the removal procedure.

7. Position the mirror glass so that the four alignment holes are over the four feet on the mirror motor and engage the mirror retainer clips to the mirror motor.

NOTE:
Pressure must be applied equally over the center portion of the mirror glass to fully engage the retainer clips.

8. Using Mopar glass cleaner (P/N 04318014AB) or equivalent, clean any finger prints from the new mirror glass and housing.