Installation

INSTALLATION




1. Before proceeding with the following repair procedure, review all warnings and cautions.


NOTE: Do not reuse the seat fasteners, always replace with new ones.

2. Install the center seat (2) and roll the seat assembly back in the vehicle.

3. Install new nuts (4) attaching the center seat to the drivers (3) and passenger seat.

4. Connect the electrical connector (1 - if equipped).

5. Tighten the nuts (4) to 25 Nm (18 ft. lbs.).





6. Install new nuts (2 and 4) attaching the center seat (1) to the drivers and passenger seat.

7. Tighten the nuts (4) to 25 Nm (18 ft. lbs.).

8. Connect the electrical connector (3 and 5 - if equipped).





9. Roll the seat assembly forward and install new rear bolts (2).

10. Connect the 12v power supply electrical connector (3 - if equipped).

11. Tighten the rear bolts to 40 Nm (30 ft. lbs.).

12. Fold the seat backs up and slide the seats to the rear.

13. Install new front bolts (4) and tighten to 28 Nm (21 ft. lbs.).