Installation

INSTALLATION

1. Install the trough guides. Installation
2. Install the sight shields.
3. Install the drive motor. Installation
4. Install the sunshade. Installation
5. Install the glass panel. Installation




6. Remove the backing tape from the foam support pad, if necessary.
7. Raise rear end of sunroof module assembly and guide into position and start fasteners.
8. Tighten the fasteners to 9 Nm (80 in. lbs.).
9. Connect the drain tubes.
10. Install the wire harness Installation.
11. Connect battery negative cable.
12. Test sunroof operation, adjust glass as necessary. Adjustments
13. Partially install the headliner and connect the sunroof wiring electrical connectors. Headliner - Installation
14. Temporarily install sunroof switch and perform the sunroof motor teach procedure. Programming and Relearning
15. Complete headliner installation. Headliner - Installation
16. Verify correct sunroof operation.