Instrument Cluster - Assembly

ASSEMBLY

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

NOTE: The cluster lens, hood and mask unit is the only component of the instrument cluster used in this vehicle that is serviced separately. Following is the procedure for assembling this component to the instrument cluster.

CLUSTER LENS, HOOD, AND MASK





1. Position the cluster lens, hood, and mask unit (2) over the face of the instrument cluster (1). Be certain that the odometer/trip odometer switch button (4) is inserted through the proper clearance holes (3) in the mask and the lens.




2. From the back of the instrument cluster (2), install and tighten the eight screws (1) around the outer perimeter of the rear cover that secure the lens, hood, and mask unit to the cluster housing. Tighten the screws to 1 Nm (10 in. lbs.).
3. Reinstall the instrument cluster onto the instrument panel. Instrument Cluster - Installation.
4. Reconnect the battery negative cable.