Restraints

U0002-CAN C BUS OFF PERFORMANCE

For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
The ORC checks for serial data message traffic at power up during the initialization process, and continuously through the ignition cycle.

- Set Condition:
This DTC sets when the ORC fails to detect serial data message traffic for more than 5 seconds. In the event the ORC detects serial data message traffic, this DTC will immediately transition to stored status.





Diagnostic Test

1. DETERMINE ACTIVE OR STORED DTC
Is the DTC active or stored?

ORC - ACTIVE DTC

- Go To 2

ORC - STORED DTC

- Perform ORC VERIFICATION TEST Occupant Restraint Controller (ORC) Verification Test

2. REPLACE OCCUPANT RESTRAINT CONTROLLER
When this code is set, view repair.

Repair

WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and serious or fatal injury.

WARNING: To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.

- Replace the ORC.
- Perform ORC VERIFICATION TEST Occupant Restraint Controller (ORC) Verification Test