Installation

INSTALLATION





The Remote Start Antenna Module Assembly consists of an electrical connection to the WCM/SKREEM (1), a length of coax cable (2), two mounting clips (3) and (4), and a control module/antenna (5).





1. Fish coax cable (1) through openings on top of instrument panel. Position module (2) to top of instrument panel.




2. Install two module mounting screws (4) to module (3).




3. Connect coax cable retainers (3) and (4) to instrument panel.




4. Connect coax cable electrical connector (2) to WCM/SKREEM.
5. Install WCM/SKREEM to steering column (1).
6. Clip upper instrument panel (IP) bezel (defroster).
7. Install left A-pillar trim.
8. Install IP cluster and its three connectors.
9. Install IP cluster bezel.
10. Install left IP end cap.
11. Install steering column trim panel (knee blocker).
12. Install steering column shrouds.
13. Connect negative battery cable.