Engine - Installation

4.7L ENGINE





1. Position engine in the vehicle.
2. Remove jack from under the transmission.
3. Remove Engine Lifting Fixture Special Tool 8347 (3).
4. Remove Special Tools 8400 Lifting Studs.
5. Position both the left and right side engine mount brackets and install the through bolts (3) and nuts. Tighten to 95 Nm (70 ft. lbs.)




6. Install transmission to engine mounting bolts (3). Tighten the bolts to 41 Nm (30 ft. lbs.).




7. Install torque converter bolts (3).




8. Connect the right (1) side body ground strap.




9. Connect the left (1) side body ground strap.
10. Position generator wiring behind the oil dipstick tube, then install the oil dipstick tube upper mounting bolt.
11. Install power steering pump.
12. Connect fuel supply line quick connect fitting Service and Repair.
13. Connect the vacuum lines at the throttle body and intake manifold.




14. Connect engine harness at the following points:
- Intake Air Temperature (IAT) Sensor (4)
- Idle Air Control (IAC) Motor (3)
- Fuel Injectors
- Throttle Position (TPS) Switch (2)
- Engine Oil Pressure Switch
- Engine Coolant Temperature (ECT) Sensor
- Manifold Absolute Pressure (MAP) Sensor
- Camshaft Position (CMP) Sensor
- Coil Over Plugs





15. Position and install heater hoses (1) and tubes onto intake manifold.
16. Install the heater hoses onto the heater core and the engine front cover, and install clips (2).




17. Install generator (3) Generator - Installation.
18. Install A/C condenser A/C Condenser - Installation, radiator Radiator - Installation and transmission oil cooler.
19. Connect radiator upper and lower hoses.
20. Connect the transmission oil cooler lines to the radiator.
21. Install accessory drive belt Accessory Drive Belt - Installation, fan assembly and shroud Radiator Fan - Installation.




22. Install A/C compressor (2) A/C Compressor - Installation.




23. Install both breathers (1). Connect tube to both crankcase breathers.
24. Connect throttle and speed control cables.
25. Install throttle body resonator assembly and air inlet hose. Tighten clamps 4 Nm (35 in. lbs.).
26. Raise vehicle.




27. Connect crankshaft position sensor (1).




28. Install starter (4) Starter Motor - Installation.




CAUTION: The structural cover requires a specific torque sequence. Failure to follow this sequence may cause severe damage to the cover.

29. Install structural cover Structural Dust Cover - Installation.
30. Install the pinion bracket.
31. Install exhaust crossover pipe.
32. Install engine block heater power cable, If equipped.
33. Check and fill engine oil.
34. Recharge the A/C system [1][2]Capacity Specifications.
35. Refill the engine cooling system Service and Repair.
36. Connect the battery positive and negative cables.
37. Start the engine and check for leaks.