Steering Column Opening Cover - Installation

INSTALLATION





1. Before proceeding with the following repair procedure, review all warnings and cautions. Service Precautions
2. Install the opening cover reinforcement (2) and seat the upper clips fully.
3. Install the screws (1).




4. Position the hood release handle (1) back and install the screws (4).




5. Snap the diagnostic connector (1) back into place on the reinforcement (2) and seat fully.




6. Position the column cover against the reinforcement and route the brake release rod through the hole in cover.
7. Seat the upper retaining clips (1) fully and install the bottom and side screws (3).




8. Connect the release rod (3) to the release handle (1) and secure the attachment clip (2) fully.




9. Position the end cap and seat the retaining clips fully.