Installation

INSTALLATION





1. Carefully position the connector receptacle on the left end of the rear park assist display housing (3) through the left end of the display opening in the lower surface of the header trim molding (1).
2. Slide the display toward the left end of the molding far enough to engage the right end of the display housing into the right end of the display opening in the molding.
3. With the display lens held flush against the lower surface of the molding, position the molded plastic retainer (2) over the display housing.
4. Slide the retainer down over the display housing until it is flash with the molding and the three tabs of the retainer are engaged in the three slots of the display housing.
5. Reconnect the wire harness connector to the connector receptacle on the left end of the display housing.
6. Reinstall the trim molding onto the upper liftgate opening header.Installation.
7. Reconnect the battery negative cable.