Removal

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions may result in accidental airbag deployment and possible serious or fatal injury.

NOTE: LHD model shown in illustrations. RHD model similar.





1. Remove the screws (3) that secure the knee blocker cover (2) to the driver side of the instrument panel (1) and remove the cover.




2. Remove the four bolts (3) that secure the knee blocker (2) to the instrument panel support (1).
3. Lift the knee blocker upwards to disengage the retaining tabs that secure the knee blocker to the support and remove the knee blocker.