2nd Row Swivel

INSTALLATION

NOTE: Right seat shown in illustrations. Left seat similar.





NOTE: Outboard side of seat shown. Inboard side similar. Illustration shown with seat back and hinges removed for clarity.

1. If removed, install the seat release handle coversSeat Release Handle - 2nd Row Swivel - Installation.
2. Position each seat riser (4) to the pivot mechanism (2) and install the four bolts (1 and 3). Tighten the bolts to 48 Nm (35 ft. lbs.).




3. If equipped with heated seats, engage the wire harness retainers (5) and install the two screws (2) that secure the electrical contact (4) to the outboard seat riser (3). Tighten the screws securely.
4. Install the seat cushion side shieldsSeat Cushion Side Shields - Installation.
5. Install the seat side shieldsSeat Side Shield - 2nd Row Swivel - Installation.
6. Install the seat into the vehicle.