step 101 - 110

ASSEMBLY

CAUTION: The cooler bypass valve must be replaced if transaxle failure has occurred. Do not attempt to reuse or clean old valve.

NOTE: If transaxle is being overhauled (clutch and/or seal replacement), the TCM/PCM Quick Learn procedure must be performed Testing and Inspection.

101. Install the manual lever, TRS and sealInstallation.









102. Install all six accumulators (1, 2, 3, 5, 6 and 7) into case along with the accumulator return springs.
103. Install a new 2/4 clutch oil supply seal (4) into the case.




NOTE: Install transmission oil on the oil transfer tubes O-rings.

104. Install the oil transfer tubes (2) into the case/compounder.




105. Install valve body (1) onto the oil transfer tubes and manual valve (3) at the rooster comb.




106. Install the valve body bolts (1) and tighten to 7 Nm (50 in. lbs.).




107. Install the detent spring (2).
108. Install the bolt (3) holding the detent spring and tighten to 7 Nm (50 in. lbs.).
109. Install the electrical connector (1) at the range sensor (4).




110. Install the valve body oil pan, use a bead of MOPAR(R) ATF RTV (MS-GF41).