step 61 - 70

DISASSEMBLY





61.
NOTE: The Low/Reverse Clutch Piston has bonded seals which are not individually serviceable. Seal replacement requires replacement of the piston assembly.
Remove low/reverse clutch piston (1).




62. Remove low/reverse piston retainer-to-case screws (3).




63. Remove low/reverse piston retainer (1).




64. Remove low/reverse piston retainer-to-case gasket (2), gasket holes must line up (1).




65. Using a hammer and suitable drift (2), drive out inner output bearing cup (1).




66. Using Remover 6062 (1), remove outer output bearing cup (2).




67. Remove the snap ring (1) at the underdrive compounder assembly (2).




68. Remove four bolts (1) at the compounder bearing retainer.




69. Install Holder 9908 (2) to the compounder bearing retainer.




70. Install Slide Hammer C-3752 (1) to Holder 9908 (2) and pull the underdrive compounder assembly from the case.