Power Windows

B210E-BATTERY VOLTAGE HIGH - DDM/PDM

For a complete wiring diagram REFER to DIAGRAMS/ELECTRICAL .


- When Monitored:
At all times.

- Set Condition:
The module senses voltage input above 15.9 volts for over 15 seconds.






Diagnostic Test


1. CHECK ENGINE DTC's
With the scan tool, read ENGINE DTC's.
Are there any ENGINE DTC's present?

No


- Go to 2


Yes


- Diagnose and repair the DTC(s).


2. TEST FOR INTERMITTENT CONDITION
With the scan tool, erase all DTC's.
Start the engine and run for 2 minutes.
With the scan tool, read DTC's.
Does the scan tool display active: B210E-BATTERY VOLTAGE HIGH?

Yes


- Replace the appropriate Door Module.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test


No


- The condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test