U0015

U0015-CAN INTERIOR BUS (-) CIRCUIT OPEN (ATC)

For a complete wiring diagram REFER to DIAGRAMS/ELECTRICAL .


- When Monitored:
Continuously

- Set Condition:
If the (D264) CAN C Interior Bus (125K) (-) circuit is open.






Diagnostic Test


1. VERIFY DTC IS ACTIVE
Turn the ignition on.
With the scan tool, read HVAC DTCs.
Does the scan tool display this DTC as active?

Yes


- Go To 2


No


- If the DTC is stored, check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test.


2. CHECK FOR ACTIVE CAN BUS RELATED DTCS IN THE TOTALLY INTEGRATED POWER MODULE (TIPM)
With the scan tool, read Totally Integrated Power Module (TIPM) DTCs
Does the scan tool display any active CAN Bus related DTCs?

Yes


- Diagnose and repair the DTC(s) before proceeding with this test.Body Verification Test.


No


- Go To 3


3. CHECK (D264) CAN C INTERIOR BUS (-) CIRCUIT FOR AN OPEN
Turn the ignition off.
Disconnect the negative battery cable.
Disconnect the A/C Heater Control (3 ZONE ATC) 32 way harness connector.
Disconnect the Totally Integrated Power Module (TIPM) C7 harness connector.
Measure the resistance of the (D264) CAN C Interior Bus (125K) (-) circuit between the Totally Integrated Power Module C7 harness connector and the A/C Heater Control (3 ZONE ATC) 32 way harness connector.
Is the resistance below 2.0 ohms?

Yes


- Replace the A/C Heater Control.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test.


No


- Repair the (D264) CAN C Interior Bus (-) circuit for an open.
- Perform BODY VERIFICATION TEST - VER 1.Body Verification Test.