Removal

REMOVAL





1. Disconnect and isolate the battery negative cable.
2. Remove the trim molding (1) from the upper liftgate opening header.Removal.
3. Disconnect the wire harness connector from the connector receptacle on the left end of the rear park assist display housing (3).
4. Carefully spread the front and rear edges of the molded plastic retainer (2) far enough to disengage the three retainer tabs from the slots in the display housing, then lift the retainer off of the display housing.
5. Push the right end of the display out through the lower surface of the molding, then slide the display toward the right side of the molding far enough to disengage the display connector receptacle from the display opening in the molding.