Removal

ADJUSTABLE

1. Move driver's seat to full rearward position.




2. Remove the instrument panel end cap and steering column opening cover (1).Steering Column Opening Cover - Removal




3. Remove the steering column cover reinforcement mounting screws (3, 4). Remove the steering column cover reinforcement (2).




4. Disconnect the wiring connector (1) at the stop lamp switch (2).
5. Rotate the stop lamp switch clockwise until the retaining tabs line up with the slot in the bracket (3), then remove and discard the switch (1). Do not reuse switch; install NEW switch upon Installation. Removal




6. Disconnect wiring connector (6) at adjustable pedals motor (7).
7. Disconnect wiring connector (2) at electronic throttle control (accelerator) (3).
8. Disconnect wiring connector (5) at brake pedal position sensor (4).
9. Remove wiring harness routing straps (1) from brake pedal bracket.




10. Remove booster push rod (2) from pin (3) on brake pedal. To do so:
a. Position small screwdriver between center tang on power brake booster brake pedal pin retaining clip (1).
b. Rotate screwdriver enough to allow retaining clip center tang to pass over end of brake pedal pin, then slide retaining clip off brake pedal pin.
c. Discard retaining clip. It is not to be reused. Install NEW retaining clip when assembling.
d. Slide booster push rod (2) off brake pedal pin (3).




11. Remove four power brake booster mounting nuts (3).




12. Remove two nuts (1) fastening pedals assembly (2) to dash panel.
13. Remove adjustable pedals assembly (2).




14. If required, remove three electronic throttle control (accelerator) mounting screws (1). Remove electronic throttle control (2).