2nd Row Swivel

INSTALLATION

NOTE: Right seat shown in illustrations. Left seat similar.





1. Install the seat belt anchor (2) and the push-pin retainer (1) onto the outboard side of the seat cushion frame (3).




2. Position the seat back and seat back hinges to the seat cushion frame as an assembly.
3. Install the two bolts (4) that secure the outboard seat back hinge (1) and the seat belt anchor (2) to the seat cushion frame (3). Tighten the bolts to 48 Nm (35 ft. lbs.).




4. Install the two bolts (3) that secure the inboard seat back hinge (2) and the seat belt latch (1) to the seat cushion frame (4). Tighten the bolts to 48 Nm (35 ft. lbs.).
5. If equipped with heated seats, connect the seat back wire harness connector.
6. Install the seat cushion side shieldsSeat Cushion Side Shields - Installation.
7. Install the seat into the vehicle.