B. Install Tie Wrap and Tab/Wedge

1. Using the supplied plastic tie strap, secure both harnesses together as shown in Figure 9. The power sliding door wiring harness must be routed to the rear (in car position) of the drive motor wiring harness.

CAUTION:
Do not over tighten the tie strap. Over tightening the tie strap may cut through the convolute or tape.

2. Cut off the tail of the tie strap and rotate the tie strap so that the tie strap lock is tucked under the wiring harnesses.

3. Install the partially removed sliding door weather seal. Be sure to tuck the wiring harness behind the weather seal inner retaining lip.

4. Move the sliding door manually and verify that the lower hinge does not contact the weather seal and/or any portion of the wiring harnesses.

5. Release the chain link track from the lower hinge pivot by pushing the locking tab forward and then push the chain link downward (Figure 10).

6. Install the supplied tab/wedge on the lower hinge pivot located on the sliding door lower hinge (Figure 10).

NOTE:
The tab/wedge must have the "L" facing up on the drivers side of the vehicle and the "R" facing up on the passenger side of the vehicle (Figure 11).

7. While holding the tab/wedge in place, snap the chain link to the lower hinge pivot.

8. Lock the chain link in place by pushing the locking tab rearward (Figure 10).

9. Repeat Section A on the passenger (right) side sliding door.

10. Connect negative battery cable and close hood.