step 1 - 10

ASSEMBLY





CAUTION: The cooler bypass valve must be replaced if transaxle failure has occurred. Do not attempt to reuse or clean old valve.

NOTE: If transaxle is being overhauled (clutch and/or seal replacement), the TCM/PCM Quick Learn procedure must be performed Testing and Inspection.

1. Install both output bearing cups (2) using Installer 5050 (1).




2. Install low/reverse piston retainer gasket (2) Make sure gasket holes line up with case (1).




3. Install low/reverse piston retainer (1).




4. Install low/reverse piston retainer-to-case screws (3) and tighten to 5 Nm (45 in. lbs.).




NOTE: The Low/Reverse Clutch Piston has bonded seals which are not individually serviceable. Seal replacement requires replacement of the piston assembly.

5. Install low/reverse clutch piston (1).




6. Install low/reverse piston return spring (1).




7. Install Disk 6057 (1), Compressor 5059 (2) and Compressor Bar 5058-3 (3).




8. Install low/reverse spring compressor into position.




9. Compress low/reverse piston and install snap ring (1).




10. Install rear carrier bearing cone (3) using Installer 6053 (1).