step 111 - 118

ASSEMBLY

CAUTION: The cooler bypass valve must be replaced if transaxle failure has occurred. Do not attempt to reuse or clean old valve.

NOTE: If transaxle is being overhauled (clutch and/or seal replacement), the TCM/PCM Quick Learn procedure must be performed Testing and Inspection.

111. Install the valve body oil pan bolts and tighten to 6 Nm (53in. lbs.).




112. Install the pressure tap plug (2) at valve body pan and tighten to 9 Nm (45 in. lbs.).




113. Install the fluid filter seal (1) at the case.




114. Install the fluid filter (2).
115. Install the fluid filter mounting nuts and tighten to 5 Nm (40 in. lbs.).




116. Install the fluid filter oil pan, use a bead of MOPAR(R) ATF RTV (MS-GF41).
117. Install the fluid filter oil pan bolts and tighten to 6 Nm (53 in. lbs.).




118. Install the speed sensors (1, 2 and 3) and tighten bolts to 12 Nm (105 in. lbs.).