step 41 - 50

ASSEMBLY

CAUTION: The cooler bypass valve must be replaced if transaxle failure has occurred. Do not attempt to reuse or clean old valve.

NOTE: If transaxle is being overhauled (clutch and/or seal replacement), the TCM/PCM Quick Learn procedure must be performed Testing and Inspection.


41. Refer to the number four thrust plate chart NO. 4 THRUST PLATE CHART to select the proper number four thrust plate.









42. Install input clutch assembly (1).




43. Install number one caged needle bearing (1) note: tanged side out (2).

CAUTION: The cooler bypass valve must be replaced if transaxle failure has occurred. Do not attempt to reuse or clean old valve.





44. Install cooler bypass valve (1) with O-ring end towards rear of case.




45. Install oil pump gasket (1).




46. Install oil pump (2).
47. Install oil pump-to-case bolts (1) and tighten 30 Nm (265 in. lbs.).




48. Install output gear stirrup (1) with serrated side out.




49. Install retaining strap (1).
50. Install strap bolts (3) but do not tighten at this time.