step 91 - 100

ASSEMBLY

CAUTION: The cooler bypass valve must be replaced if transaxle failure has occurred. Do not attempt to reuse or clean old valve.

NOTE: If transaxle is being overhauled (clutch and/or seal replacement), the TCM/PCM Quick Learn procedure must be performed Testing and Inspection.

91. Install differential oil seals into the case using installer MD998334-01.




92. Install the oil scavenger (2).




93. Install the transfer gear cover (1), use a bead of MOPAR(R) ATF RTV (MS-GF41). 
94. Install transfer gear cover-to-case bolts (2) and tighten to 12 Nm (105 in. lbs.).




95. Install the park pawl tube (1) into case (2) making sure guide pin aligns with hole in case.




96. Install the snap ring (1) for the park pawl tube.




97. Install the park pawl (1) and the park pawl spring (2).




98. Install the park pawl shaft (1).




99. Install the park pawl shaft and park pawl pipe plug tighten to 27 Nm (20 ft. lbs.).




100. Install the set screw (1) for the park pawl shaft and tighten to 1 Nm (10 in. lbs.).