Left Cylinder Head

LEFT CYLINDER HEAD





NOTE: The cylinder head bolts are tightened using a torque plus angle procedure. The bolts must be examined BEFORE reuse. If the threads are necked down (2) the bolts should be replaced.
Necking can be checked by holding a straight edge against the threads. If all the threads do not contact the scale, the bolt should be replaced.




CAUTION: When cleaning cylinder head and cylinder block surfaces, DO NOT use a metal scraper because the surfaces could be cut or ground. Use only a wooden or plastic scraper (1).

1. Clean the cylinder head and cylinder block mating surfaces.




2. Position the new cylinder head gasket on the locating dowels.

CAUTION: When installing cylinder head, use care not damage the tensioner arm or the guide arm.

3. Position the cylinder head onto the cylinder block. Make sure the cylinder head seats fully over the locating dowels.

NOTE: The four smaller cylinder head mounting bolts require sealant to be added to them before installing. Failure to do so may cause leaks.

4. Lubricate the cylinder head bolt threads with clean engine oil and install the ten M11 bolts.
5. Coat the four M8 cylinder head bolts with Mopar(R) Thread Sealant with PTFE then install the bolts.

NOTE: The cylinder head bolts are tightened using an torque angle procedure.

6. Tighten the bolts in sequence using the following steps and torque values:
- Step 1: Tighten bolts 1-10, 20 Nm (15 ft. lbs.).
- Step 2: Tighten bolts 1-10, 47 Nm (35 ft. lbs.). Tighten bolts 11-14, 25 Nm (18 ft. lbs.).
- Step 3: Tighten bolts 1-10, 90 degrees. Tighten bolts 11-14, 30 Nm (22 ft. lbs.).





7. Position the secondary chain onto the camshaft drive gear, making sure one marked chain link is on either side of the V8 mark on the gear and position the gear onto the camshaft.
8. Install the camshaft drive gear retaining bolt.
9. Install the left side secondary chain guide. Timing Chain & Sprockets - Installation




10. Install the cylinder head access plug (2).
11. Re-set and Install the left side secondary chain tensioner. Timing Chain & Sprockets - Installation




12. Remove Secondary Camshaft Chain Holder 8429 (6).
13. Install the timing chain cover. Timing Cover - Installation
14. Install the crankshaft damper. Vibration Damper - Installation
15. Install the power steering pump.
16. Install the fan blade assembly and fan shroud.




17. Install the cylinder head cover. Cylinder Head Cover - Installation
18. Reinstall the master cylinder and booster assembly.
19. Install the intake manifold. Intake Manifold - Installation
20. Fill the cooling system. Service and Repair
21. Raise the vehicle.
22. Install the exhaust pipe onto the left exhaust manifold.
23. Drain oil.
24. Lower the vehicle.
25. Fill with oil.
26. Connect the negative cable to the battery.
27. Start the engine and check for leaks.