Restraints

B2206-CURRENT VIN MISSING/MISMATCH

For a complete wiring diagram Refer to Diagrams/Electrical.


- When Monitored:
During power-up, the ORC monitors the CAN bus for the PCM VIN message.


- Set Condition:
This DTC will set if the VIN information received from the PCM is different from the stored ORC VIN.







Diagnostic Test


1. CHECK FOR ACTIVE DTC
NOTE: Ensure that the battery is fully charged.

With the scan tool, read DTC.
Select the module and DTC type.

ORC-Active


- Go To 2


ORC-Stored


- Erase code with scan tool, test complete.



2. CHECK THE VIN STORED IN THE PCM
With the scan tool, compare the VIN that is stored in the PCM to the VIN of the vehicle's VIN plate.
Does the VIN that is stored in the PCM match the vehicle's VIN?

Yes


- Go To 3


No


- Replace and Configure the Powertrain Control Module.
- Perform (NGC) *POWERTRAIN VERIFICATION TEST VER - 5.Powertrain Verification Test



3. REPLACE THE OCCUPANT RESTRAINT CONTROLLER
WARNING: To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.

WARNING: If the airbag control module is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and serious or fatal injury.

View repair.

Repair


- Replace the Occupant Restraint Controller.
- Perform *ORC VERIFICATION TEST-VER 1.