Installation

INSTALLATION





CAUTION: Prior to installing the rear fenders, mask off the surrounding areas to avoid damage to the cargo box painted surfaces.

1. Carefully position the rear fender onto the three bolts (3) on each of the two support brackets (1) located on the cargo box outer panel (2).




2. Install the four nuts (2) that secure the front of the rear fender to the cargo box inner panel (1). Tighten the nuts to 7 Nm (60 in. lbs.).




3. Install the two nuts (1) that secure the rear fender to the rear of the cargo box inner panel (2). Tighten the nuts to 7 Nm (60 in. lbs.).
4. Install the four bolts that secure the bottom edges of the rear fender to the cargo box. Tighten the bolts to 7 Nm (60 in. lbs.).
5. Tighten the three bolts on each of the two support brackets to 11 Nm (8 ft. lbs.).




6. Lower the vehicle.
7. Install the two nuts (2) that secure the rear fender to the cargo box near the tail lamp opening (1). Tighten the nuts to 7 Nm (60 in. lbs.).
8. Install the two marker lamp units onto the rear fender Marker Lamp - Installation .
9. Install the rear wheelhouse splash shield Installation .
10. Install the tail lamp unit Rear Lamp Unit - Installation .
11. Reconnect the negative battery cable.