Installation

INSTALLATION





WARNING: The Excessive Force Limitation (EFL) feature must be calibrated any time a sunroof motor/module is replaced with a new component. Failure to perform this procedure could result in vehicle damage and/or personal injury. for the appropriate procedure.

1. Raise sunroof module assembly (1) and guide it carefully into position.
2. Hand start the eight screws (2).
3. Line up the locating holes and tighten the attaching screws (2) to 9 Nm (80 in. lbs.).




4. Connect the electrical connector (1).




5. Connect the drain tubes (1) to the sunroof.
6. Connect battery negative cable.
7. Install the glass, Installation .
8. Install the vehicle headliner, Headliner - Installation .
9. Perform the sunroof position calibration, Sunroof Position Calibration .
10. Perform the Excessive Force Limitation (EFL) calibration, .
11. Verify proper operation of the power sunroof system.