Installation-Cab/Chassis Models

REMOVAL-CAB/CHASSIS MODELS





1. Disconnect and isolate both negative battery cables at batteries.
2. Remove four bolts (2) and EGR crossover tube cover (1).




3. Remove heat shield (2) over EGR valve (1).




4. Disconnect electrical connector (4) at EGR Temperature Sensor.
5. Loosen and remove two clamps (1) and (3) at ends of EGR Crossover Tube.
6. Remove "P" clamp mounting bolt (5) at center of EGR Crossover Tube.
7. Remove EGR Crossover Tube (2).
8. Remove and discard gaskets (doughnuts) at each end of tube.