U110E

U110E-LOST AMBIENT TEMPERATURE MESSAGE





For a complete wiring diagram Refer to Diagrams/Electrical.


- When Monitored:
Ignition on.

- Set Condition:
The PCM doesn't receive the ambient temperature signal over the CAN C bus from the TIPM. The circuit is continuously monitored. One Trip fault.







Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Initial Inspection and Diagnostic Overview .

Theory of Operation


The ambient temperature sensor signal is a direct input to the TIPM. The TIPM sends the PCM the ambient temperature signal over the CAN C bus.


Diagnostic Test


1. ACTIVE DTC
Ignition on, engine not running.
With the scan too, select View PCM DTCs.
Is the DTC Active at this time?

Yes


- Go To 2


No


- Refer to the INTERMITTENT CONDITION Diagnostic Procedure. Intermittent Condition



2. U0141-LOST COMMUNICATION WITH FRONT CONTROL MODULE (TIPM) ALSO ACTIVE
With the scan too, select View DTCs.
Is the U0141-NO BUS MESSAGE RECEIVED FROM THE TIPM also set?

Yes


- Follow the diagnostics for U0141-LOST COMMUNICATION WITH FRONT CONTROL MODULE (TIPM).
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test


No


- Replace and program the Powertrain Control Module.
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test