Installation

INSTALLATION





The Remote Start Antenna Module Assembly consists of an electrical connection to the WCM/SKREEM (1), a length of coax cable (2), two mounting clips (3) and (4), and a control module/antenna (5).





1. Connect coax cable electrical connector (1) to WCM/SKREEM module (2).



Route coax cable and install cable clip (2) to IP.




2. Position module (1) and install two module mounting screws (2).
3. Install IP cluster and its three connectors.
4. Install IP cluster bezel.
5. Install steering column trim panel (knee blocker).
6. Install steering column shrouds.
7. Connect negative battery cable.