4X4 - Independent Front Suspension

4X4





1. Install the brake dust shield (2).
2. Install the hub/bearing (1) into the steering knuckle (3) and tighten the bolts to 163 Nm (120 ft. lbs.).
3. Install the brake rotor and caliper Brake Rotor - Installation .
4. Install the ABS wheel speed sensor if equipped Front Wheel Speed Sensor - Installation .
5. Install the upper ball joint nut to the steering knuckle and tighten to 54 Nm (40 ft. lbs.) (on 1500 series only an additional 90° turn).
6. Install the tie rod end nut to the steering knuckle and tighten to 61 Nm (45 ft. lbs.) then an additional 90°.
7. Install the halfshaft nut and tighten to 251 Nm (185 ft. lbs.).
8. Install the wheel and tire assembly Removal and Replacement .
9. Remove the support and lower vehicle.