Installation

INSTALLATION





1. Verify output shaft bearing cup (1) is seated in disconnect pocket (2).




2. Install output shaft (1) in disconnect pocket (2).




3. Install disconnect seal (1) on output shaft (2).




4. Align disconnect seal (1) with bolt holes in disconnect pocket with Pins MD998412 (2).




5. Install disconnect seal (1) in disconnect pocket with Installer 6761 (2) and a hammer.




6. Install disconnect seal (1) bolts (2) and tighten to 28 Nm (21 ft. lbs.).




7. Install output shaft O-ring (1) and snap ring (2).
8. Install half shaft.
9. Verify differential fluid level and add fluid if necessary.