B199C

B199C-RIGHT POWER SLIDING DOOR POSITION SENSOR 1 CIRCUIT PERFORMANCE





For a complete wiring diagram Consult Diagrams/Electrical

- When Monitored:
Anytime the Right Power Sliding Door is performing a power operation.

- Set Condition:
This code will set when the Right Power Sliding Door module does not receive the Right Power Sliding Door Sensor 1 Signal pulses.





Diagnostic Test

1. CHECK FOR DTCS
With the scan tool, record DTC's and any power sliding door inhibitors.
Erase the DTCs.
Turn the ignition off, wait 10 seconds, then turn the ignition on.
Attempt to operate the Right Power Sliding Door
With the scan tool, read DTCs.

NOTE: If there are any Door Sensor Supply DTC's displayed, repair them first before proceeding.

Does the scan tool display this DTC?

Yes

- Go To 2

No

- Using the wiring diagrams as a guide, inspect the wiring and connectors for an intermittent condition.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test.

2. CHECK THE RIGHT POWER SLIDING DOOR
Examine the Right Power Sliding Door for proper alignment, worn or binding rollers and hinges, loose/damaged weatherstrip, and track assembly for wear or anything that would cause an obstruction to proper operation.
If necessary manually operate the Right Power Sliding Door on a known good vehicle and notice the effort needed to open and close for comparison.
Especially notice the effort needed to unlatch and close the Right Power Sliding Door.
Were there any mechanical problems found?

Yes

- Refer to Service information for the related procedure(s).
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test.

No

- Go To 3

3. CHECK THE DOOR POSITION SENSOR 1 SIGNAL CIRCUIT




NOTE: At this time it will be necessary to remove the Power Sliding Door Drive Unit Assembly from the vehicle.

Turn the ignition off.
Remove the Power Sliding Door Drive Unit Assembly from the vehicle.
Remove the Power Sliding Door Module from the track.
Re-connect the Power Sliding Door Module to the track harness connector.
Turn the ignition on.
With the scan tool, monitor the Position Sensor 1 state.
Connect a jumper wire to the Door Position Sensor 1 Signal terminal in the PSDM C2 (component side) connection.
Momentarily touch and release the other side of the jumper to the Door Position Sensor Return terminal in the PSDM C2 (component side) connection several times and observe the Position Sensor 1 states on the scan tool.
Does the state of the position sensor change each time the jumper is connected and then released?

No

- Replace the Power Sliding Door Module.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test.

Yes

- Replace the Power Sliding Door Drive Unit.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test.