Instrument Panel Cluster Bezel - Installation

INSTALLATION

WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury.





1. Install the bezel (1) and install the screws (2).
2. Install the ignition switch bezel (3), Installation.
3. Install the steering column opening cover, Steering Column Opening Cover - Installation.




4. Install the instrument cluster (2), Instrument Cluster - Installation.




5. Install the steering wheel (1), Installation.
6. Instal the side air nozzles (1), Front Distribution Rear Distribution.




7. Install the air outlet covers (1) from the instrument panel center section and install the screws (2).
8. Connect the electrical connector and install the center bezel. Seat the clips fully.