Event 0929

EVENT 0929-ENGINE CAN BUS - PLAUSIBILITY ERROR OF VEHICLE SPEED SIGNAL VIA CAN

For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
Ignition on and battery voltage greater than 10 volts.

- Set Condition:
An active DTC is stored in the ESP Module. One Trip Fault. Three good trips to turn off the MIL.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Initial Inspection and Diagnostic Overview.

Diagnostic Test

1. DTC PRESENT IN ETC CONTROLLER
This is an informational DTC letting you know that a DTC(s) is stored in the Electronic Stability Control Module or a CAN bus Failure occured.
Using a scan tool, read the Electronic Stability Control Module DTC and perform the appropriate Diagnostic Procedure.
PCM Diagnostic Information complete.

Continue

- Test Complete.